Console Setup for Soundcraft stagebox

Set up information for the stagebox itself can be found here.  This page includes details on how the faders are set up on the consoles when loading the stagebox show file.  This is not the standard room setup, so you will need to review this information to be familiar with the setup on the console. 

MB 1

Console

·         Load default show file on console called Default with Stagebox MB 1.

·         Layer 1 set up  : 1- 10 mics, 11- rev, 12 – delay, 13 - W1, 14 – W2*

o   *if console is in the house, it has to be patched to house console inputs 9, 10 from booth console patch location.

·         Layer 2 set up : 11 – 24 mics

·         Outputs : Left – stagebox ouput 11, Right – stagebox output 12, N/S mono – stagebox output 10

·         Console MADI must be patched directly to stagebox location via data tie line.

Restoring the room

·         Be sure to restore all original cable connections including the MADI data line, and XLR connections in the amp room stagebox.

·         Restore the original show file and test audio in the room to ensure that everything has been restored properly.

MB 2

Console

·         Load default show file on console.

·         Outputs : L – stagebox ouput 11, R – stagebox output 12, N/S mono – stagebox output 10

·         Console MADI must be patched directly to stagebox location via data tie line.

Restoring the room

·         Be sure to restore all original cable connections including the MADI data line, and XLR connections in the amp room stagebox.

·         Restore the original show file and test audio in the room to ensure that everything has been restored properly.

MB 3

Console

·         Load default show file on console called Default with Stagebox MB 3.

·         Layer 1 set up  : 1- 10 mics, 11- rev, 12 – dly, 13 - W1, 14 – W2*

o   *if console is in the house, it has to be patched to house console inputs 9, 10 from booth console patch location.

·         Layer 2 set up : 11 – 24 mics

·         Outputs : Left – stagebox ouput 11, Right – stagebox output 12, N/S mono – stagebox output 10

·         Console MADI must be patched directly to stagebox location via data tie line.

Restoring the room

·         Be sure to restore all original cable connections including the MADI data line, and XLR connections in the amp room stagebox.

·         Restore the original show file and test audio in the room to ensure that everything has been restored properly.